Lift the dishwasher from the front about 3-4 inches and place a piece of wood or similar item underneath the dishwasher to keep it in a tilted-up position.When open, disconnect the wires by undoing the wire nuts (make sure you note which wires go where for when you have to put them back together again). You can do this by unthreading the screws that hold the junction box cover in place. Remove the power supply cord from the junction box.When pulling the dishwasher out, make sure that the water hoses can come out with it and are not stuck. If required, adjust the dishwasher legs so that you can pull it out from its position.Open the dishwasher door and unthread the two screws that secure the mounting bracket to the countertop or cabinet (if applicable).
Disconnect the drain hose from the sink drain or garbage disposal unit.You might want to put a towel down underneath it, as water may come out of the waterline when you remove it. Unscrew the rest of the elbow fitting until the water supply line is disconnected.Use a pair of channel lock pliers to loosen the elbow fitting that connects the water supply line to the water inlet valve.Once removed, set the panel aside out of the way. You’ll need to unthread the two screws that are holding it in place. The first thing to do is to remove the lower access panel.Start by disconnecting the power at the wall.This guide covers most models of Electrolux dishwashers, including: Simply follow our step-by-step instructions below to remove the faulty drain pump and then reinstall the new one. Do you need to replace the drain pump in your Electrolux dishwasher? The good news is that it’s a pretty straightforward repair to make, so it doesn’t require a high level of technical knowledge.
0 kommentar(er)
